Copper Strip Jacket Production Calculations The following is a chart of production output for a given material input (that is, how many bullets or jackets you can make with a certain number of pounds of copper strip, lead wire, etc.). Naturally... Jacketed Bullets Lead Bullets
About Corbin Ceramic Heat Treatment Blocks Corbin Manufacturing now offers easily-machinable ceramic foam heat treatment blocks, to make jacket and bullet holders for bonding cores and heat treating jackets. The new blocks are available both a... Jacketed Bullets
About Corbin Point Form Die Ejection Pins The Point Form Die (PF-1) puts the ogive curve on a lead or jacketed bullet. It is used after the core has been seated in the core seating die, which in turn is used after the core has been swaged to ... Bullet Swaging Jacketed Bullets Lead Bullets Precision Dies
About Corbin JRD-1-R, JRD-1-S and JRD-1-H Jacket Reducing Dies Corbin builds the JRD-1 and JRD-2 jacket reducing die sets, each in type -S (for the 5/8-24 ram S press with 7/8-14 die threads) and in type -H (for the 1.0-12 ram H press with 1.5-12 die threads). In... Jacketed Bullets Precision Dies
About Corbin Jacketed Bullet Making The basic steps in swaging almost any jacketed bullet are: Swage the core to exact weight/size using CSW-1 Core Swage Seat the core into the jacket using CS-1 Core Seater For rebated boattails instead... Bullet Swaging Jacketed Bullets Lead Bullets
About Swaging Corbin Bullet Jackets General Jacket Information Jackets are the "skin" of a bullet, starting as empty cylinders which are then filled with compressed core material, expanded to exact diameter, and shaped into the bullet d... Bullet Swaging Jacketed Bullets
About Corbin Point Forming Dies The Point Form Die (PF-1) puts the ogive curve on a lead or jacketed bullet. Normally, it is used after the core has been seated into the jacket in a core seating die, or for lead bullets, after the l... Jacketed Bullets Lead Bullets Precision Dies
About Corbin ET-2-S Adjustable-Length Jacket Trim Die The Corbin ET-2-S jacket trimming die, for use in the Corbin S-Press, uses a tapered punch to expand the trimmed ring so is very lightly attached to the jacket where it can be flicked off by hand upon... Jacketed Bullets Precision Dies
About Corbin Center Fired Case To Bullet Jacket Converter Turn Fired Center-Fire Cases into Bullet Jackets! Jackets for 308 rifle bullets can be made from fired 9mm cartridge cases with this draw die set. The quality of bullet is reasonable for hunting and i... Jacketed Bullets Precision Dies
Thin Wall 45 Pistol Jackets A new line of .45 pistol jackets for improved performance with lower velocity loads is now available from Corbin. The thin-walled jacket, catalog number J-45-540, is approximately .540 inches tall, an... Jacketed Bullets
Make .30 Jackets from Pennies Using the Corbin JMK-P-H Jacket Maker Kit, you can convert copper pennies into rather good inch-long 308 bullet jackets, assuming you use either the CHP-1 Hydro Press or the CSP-2 Mega Mite press with... Jacketed Bullets
About Corbin Point Forming Dies The Point Form Die (PF-1) puts the ogive curve on a lead or jacketed bullet. It is used after the core has been seated in the core seating die, which in turn is used after the core has been swaged to ... Bullet Swaging Jacketed Bullets Lead Bullets Precision Dies