WELCOME TO OUR NEW WEBSITE! We are adding products everyday, but if you do not see what you are looking for go to our legacy page at bulletswage.com

About Corbin CHP-T Catcher Tray

The CHP-T Catcher Tray is used with the Corbin Hydro-Press (CHP-1) or the Corbin Mega Mite press (CSP-2) to catch lead extrusions or spent primers, and prevent them from falling into the ram slot, or piling up on the top of the Hydro-Press. The Catcher Tray has two sections:

  1. Three-sided top with 1-1/2+ inch mounting hole (fits easily over the -H die, against ram guide plate), and...
  2. Four-sided box, which hangs off the rear of the ram guide plate and holds ejected material.



To install the new Catcher Tray, slip it over the swage die in the press ram! To dump it, just lift it off. (The previous version had a mounting hole that went UNDER the die and was clamped against the ram plate, but this interfered with quick dumping and replacement as well as the sync length of special point form dies).

Please note that the catcher tray does not need to be "secured" or parallel to the ram plate: it actually works better if you just let it hang at a slight angle, held by the die but easily removed. The angle lets extrusions or primers roll or slide down into the "box" portion more easily.

The Catcher Tray can also be used with type -R and type -S bullet or jacket reducing dies as well as -H type, by hanging the unit on the top of the draw die, at a slight angle with the 1-1/2 inch hole over the die top. The jackets or drawn bullets emerge from the top of the die and, instead of you having to catch them or letting them fall to the floor, they will drop into the catcher tray. When the tray is full, you can lift it off and pour the content in to another container.


Sign in to leave a comment
About Corbin CHP-B2 1.25x12 to 1.50x12 Adapter